|
The wire component used to make this bracelet can be made on any WigJig.
The pattern shown at right is for one of our jigs with a circular peg
pattern. The pattern shown below right is for one of our jigs with a
square peg pattern like the WigJig Delphi. |
|
|
Step 1: Cut and make a loop in a 1-7/8" segment of 16 or 18 gauge
wire.
Step 2: Straighten the wire by pulling it through the jaws of your nylon jaw pliers while holding the initial loop. Step 3: Place the initial loop on peg one of your peg pattern. Position peg 2 in your jig, but not peg 3. Wrap the wire around peg 2 as shown above, leaving the wire resting adjacent to the hole for peg 3. This will require pushing the wire just beyond the hole for peg 3 and letting it relax back into that position. Step 4: Add peg three to your jig and wrap the wire around peg 3 as shown. Step 5: Remove the wire from your jig and cut the excess wire. Close the final loop made on peg 3 with your bent chain nose pliers. Step 6: Harden and flatten the wire component by squeezing it in the jaws of your nylon jaw pliers. |
|
