Page 3  Two to One Beaded Bracelet Jewelry Making Project

Step 8:  Now we begin to build the bracelet.  Start by connecting one of the wire components (component A at right) to another (component B) with a wrapped bead link and an 8mm bead (bead 1).  Connect the middle hole on component A to the middle hole on the component B.  Instructions for making the wrapped bead link can be found here. 

Step 9:  Next we need to connect the outside holes in wire component A to the next wire component, component C.  Using the same technique for the wrapped bead link and your 8 mm beads, connect the loop made on peg 1 in component A to the loop made on peg 3 in the next component (component C) using wrapped bead link 2 shown at right.  Then with another 8mm bead connect the loop made on peg 3 in component A to the loop made on peg 1 in component C using wrapped bead link 3.  This will require you to cut any excess wire as you wrap the second part of this wrapped bead link closed to a length of about 7/16" long so that it will be able to wrap without getting caught in bead 2.