|
Step 11: At this point in assembling the bracelet we have four wire
components connected (A, B, C and D). We now need to add component
E, the last one on this side of the bracelet. This is done using 8mm
beads and wrapped bead links 5 and 6.
Step 12: Connect the center loop in component E to wrapped bead link and 8mm bead number 7 as shown at right. Finish the second loop in wrapped bead link 7 as a regular wrapped loop, not connected to anything. Step 13: Use wrapped bead link 8 to connect between the ending loop in wrapped bead link 7 and your commercial clasp. If you want a bracelet that is 7-1/2 inches long (the normal length for a bracelet), then the bead used for wrapped bead link 8 should be 2.5mm in size. It is hard to see in the pictures at right, but a 2.5mm round, gold-filled bead was used in the bracelet shown. At the same time that you connect your clasp to wrapped bead link 8, also connect your guard chain if you decide to use one. Step 14: Repeat steps 11, 12 and 13 on the opposite end of the bracelet to complete the other side of the bracelet. This completes your 2-1 bracelet. |
|
