30 Degree Spiral Jewelry Wire & Beads Earrings Jewelry Making Project -- Page 3

Step 6:  Remove the wire component from your jig.  Reposition peg 1 as shown at right.  Replace the wire component on your jig and wrap the wire around peg 4 as shown. 

Step7:  Remove the wire component from your jig.  Reposition peg 1 as shown at left.  Replace the wire component on your jig and wrap the wire around peg 4 as shown. 

Step 8:  Remove the wire component from your jig.  Reposition peg 1 as shown at right.  Replace the wire component on your jig and wrap the wire around peg 6 as shown. 

Step 9:  Remove the wire component from your jig.  Reposition peg 1 as shown at left.  Replace the wire component on your jig and wrap the wire around peg 6 as shown. 

Step 10:  Remove the wire component from your jig.  Flatten and harden the component by repeatedly squeezing it in the jaws of your nylon jaw pliers.  Change the orientation of your pliers as you squeeze so that you can flatten the entire component.  At this point the wire component should appear as shown at right.