|
Step 9: Remove peg 2 and push the wire so that it wraps around peg 3 as shown below-center. Push the wire with the tip of the index finger on your dominant hand. Step 10: Remove your wire component from the jig. Add peg 2 to your pattern and replace your wire component in the position shown below center. Step 11: Push the wire around peg 4 and continue pushing until the wire rests adjacent to peg 1 as shown below-right. Please note that you will probably have to lift the wire over peg 1 so that you can push the wire slightly beyond peg 1. Continue pushing the wire until the wire rests against peg 1 with no pressure applied.
Our instructions for making this necklace continue on the next page. |
Step
8: Remove the wire component from your jig. Add pegs 3
and 4 to your pattern and replace the wire component on your jig with
the initial loop on peg 1 and your second loop on peg 4 as shown at
right.
