3 Strand Jewelry Wire & Beads Necklace Jewelry Making Project -- Page 4

Step 12:  Continue pushing the wire around peg 1 as shown at right. 

Step 13:  Remove the wire component from the jig and replace it in the mirror image position as shown below-left. 

Step 14:  Pull the wire up and over the wire component at the narrow point where the two wires cross.  See the picture below-center.  The reason that we are performing this wrap is that it will make the wire component permanent.  Leaving the wire component on the jig will preserve the shape of the wire. 

Step 15:  Remove the wire component from the jig and replace it on the jig in the mirror image position as shown below-right. 

Step 13	Step 14	Step 15

Our instructions for making this necklace continue on the next page.