|
The three wire components used to make the body of these earrings are
shown at right. We also need a modified figure 8 connector and an
ear wire finding to complete these earrings. Our instructions for
making this jewelry item begin with the top wire component. On page
3 we will provide the instructions for the 3 loop wire component and for
how to connect the 3 loop component to the top wire component. On
page 4 we provide instructions for the 5 loop wire component and on page 6
we provide instructions for assembling the earrings including the modified
figure 8 connector and the ear wire finding. |
 |
|
Step 1: Cut and make a loop in one end of a piece of 20 gauge wire 2 inches
long. 1/2 hard wire is preferred. Step 2: Straighten this wire. Step 3: Place pegs 1 and 2 into your WigJig Cyclops or Centaur as
shown at right. Put the initial loop on peg 1 and wrap the wire
around peg 2 1-3/4 times so that it rests against the hole where peg 3
would go. |
 |
