|
Step 8: Cut and make a loop in one end of a piece of 20 gauge wire
1-1/2 inches long.
Step 9: Straighten this wire using your nylon jaw pliers. Step 10: Position pegs 1 and 2 in your jig as shown at right. Place the initial loop on peg 1 and wrap the wire around peg 2 so that it rests against the hole for peg 3. Step 11: Now add peg 3 and wrap the wire around this peg. Step 12: Remove the wire from the jig and cut the excess wire.
Now using your bent chain nose pliers, close the loop made on peg 3. |
|
| Step 13: Now we need to connect the top wire component to the 3 Loop wire component. First open one of the bottom loops in the Top Wire Component using your bent chain nose pliers and insert the corresponding loop from the 3 Loop wire component. Then on the opposite side, open both the loop in the Top Wire Component and the loop in the 3 Loop wire component and connect these two loops. Once the wire is in position, close both loops. At this point the two wire components should appear as shown at right. |
 |
