| HOME BEGINNERS JEWELRY INSTRUCTIONS WIGJIG UNIVERSITY WHAT'S NEW GIFT IDEAS WIGJIG STORE |
| VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD TOOLS WATCHES WIRE |
|
Now we need to make the 5 Loop wire component.
Step 14: Cut a piece of 20 gauge wire 3 inches long. Make a loop in one end of the wire. Step 15: Straighten the wire using your nylon jaw pliers. Step 16: Place pegs 1 and 2 in your jig as shown at right. Place your initial loop on peg 1 and wrap the wire around peg 2 so that it rests against the hole for peg 3. |
|
| Step 17: Remove the wire from the jig and add peg three.
Place the initial loop on peg three and wrap the wire around peg 1. Step 18: Remove the wire from the jig and add peg four. Place the initial loop on the jig and wrap the wire around peg four. Step 19: Now add peg five and wrap the wire around peg 5. Step 20: Remove the wire from the jig and cut the excess wire. Close the loop made around peg 5 with your bent chain nose pliers. In the following pages we will discuss how to assemble these earrings. |
Page 4 Next Page
Return to Jewelry
Making Tools, Beads, Wire and Jewelry Supplies by WigJig Home
See our selection of jewelry making
supplies including beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: February 24, 2008
