|
The first step in assembly of these earrings is to connect a bead to the
middle loop of the top wire component. This is accomplished with a
head pin inserted into a bead connected as a bead dangle to the middle
loop in the top wire component.
Instructions for this jewelry making technique can be found here.
The second step in the assembly of these earrings is to connect the top
wire component and the 5 loop wire component as shown at right. (The
bead is not shown in this picture.) Making this connection is
accomplished by opening the loop on one side of the top wire component and
connecting that loop to one of the end loops on the 5 loop wire component,
then closing the loop in the top wire component. To connect the
opposite end of the two components, both the end loop in the 5 loop wire
component and the end loop in the top wire component must be opened.
The two loops are then connected and once connected, both loops are
closed. At this point we are ready to start adding beads. |
|
