|
Step 8: Now we begin to make the top wire component. Cut a 2-3/4"
segment of wire and make a loop in one end. Step 9: Straighten this wire segment. Step 10: Position pegs 1 and 2 in your WigJig Cyclops, Centaur or Electra as shown at right. Place the initial loop on peg 1 and wrap the wire around peg 2 so that the wire rests next to the empty hole for peg 3 with no pressure being applied. Step 11: Now add peg 3 to the pattern and wrap the wire around peg 3. Step 12: Remove the wire from the jig and cut the excess wire. Step 13: Using your bent chain nose pliers close the loop made
around peg 3. |
|
|
Step 14: Using the tips of your round nose pliers bend the loops at
the ends of the top wire component so that they are eye loops.
You can view how to
do this at the bottom of this page. Step 15: Now, one at a time, bend these eye loops 90 degrees. When completed, the loops are perpendicular to the rest of the top wire component as shown at right. |
|
