| HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE |
| VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE |
|
Step 1: Cut a 3 1/2 inch segment of soft 20 gauge wire.
Step 2: Make a loop in the end of the wire with the flush cut. Step 3: Straighten the wire. Step 4: Position peg 1, a regular metal peg, and peg 2, a 1/4"
Super Peg in your jig as show at right. Place the initial loop on peg 1
and wrap the wire around peg 2. |
|
| Step 5: Add peg 3, a 1/4" Super Peg to your jig as shown and
wrap the wire around peg 3 then the other side of peg 2. Step 6: Add peg 4, a regular metal peg and wrap the wire under and around peg 4. Step 7: Remove the wire from the jig and using your fine step jaw pliers or your round nose pliers complete the loop around peg 4. Step 8: Cut the excess wire with your flush cutter. Step 9: Using your bent chain nose pliers, close the loop made on peg 4. Step 10: Hand finish your Figure 8 Dangle wire component. Shaping it with your fingers. |
Page 2 Next Page
WigJig Jewelry
Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of
beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 09/04/2008
