|
Step 11: While holding the wire component with your round nose pliers, bend the wire to the position shown at right. Step 12: Remove the wire from your pliers and it should appear as shown below-left. Step 13: Using your bent chain nose pliers grasp the first of the two larger loops as shown below-center. You will need to hold this loop firmly while you wrap the initial wire segment around the wire between the two loops. By holding it with your pliers you preserve the shape of the loop. Step 14: Using the thumb on your dominant hand, push the initial wire segment so that it wraps around about 180 degrees as shown below-right.
These instructions continue on the following web page. |
