Making a Jewelry Wire Bail Finding --
A Beginner's Jewelry Making Technique -- Page 3

Step 7:   Now bend the long wire segment up 90 degrees while continuing to grip the wire firmly with your round nose pliers. 

Step 8:  Remove the wire from the jaws of your round nose pliers.  Adjust the wire so that it appears as shown below-left with no pressure applied. 

Step 9:  Place this wire component on your jig, on the 3/16 inch Super Peg as shown below-center.  We are using the jig and the Super Peg to preserve the round shape of the bail while we wrap the 1 inch wire segment around the longer wire tail. 

Step 10:  Hold the wire on your jig and in position on the 3/16 inch Super Peg and using your fingers lift the short, 1 inch wire segment and bend it over the longer wire segment as shown below-right.  Push the wire down with your fingers as close to the bend in the short wire segment as possible.  This helps to keep this wrap tight. 

Step 8	Step 9	Step 10

These instructions continue on the following web page.