Making a Triangular Jewelry Wire Bail Finding --
An Advanced Beginner's Jewelry Making Technique -- Page 22

Triangular Bail (Continued):

Step 9:  Pull the initial segment of wire up and over while holding the triangles of wire in position on the pegs in your jig.  This step gets the wrap of wire started in the correct position.  See the picture at right. 

Step 10:  Remove the wire from your jig.  It should appear as shown below-left. 

Step 11:  Using your bent chain nose pliers grasp the long wire tail immediately below the triangles and bend the wire about 30 to 45 degrees as shown below-center. 

Step 12:  Grasp the wire at the 30 to 45 degree bend with your bent chain nose pliers and bend the wire so that it is parallel to the beginning wire segment as shown below-right. 

Step 10	Step 11	Step 12

These instructions continue on the next web page.