Making a Triangular Jewelry Wire Bail Finding --
An Advanced Beginner's Jewelry Making Technique -- Page 27

Triangular Jewelry Wire Bail (Continued):

Step 27:  Place your triangles of wire back on the jig and add a 3/16" Super Peg as shown at right.  This peg is slightly off center and we will correct for that in a later step.  Your goal is to place your Super Peg so that it is barely in contact with the wire as near the 90 degree bend in the wire as possible. 

Step 28:  Now wrap the wire tail around the Super Peg as shown below-left. 

Step 29:  Remove the wire from your jig and it should appear as shown below-center.  Please note that the circle of wire is slightly off the center line of the triangles. 

Step 30:  Place your 3/16" Super Peg back in your jig and place the circle of wire back on this peg.  Now adjust the wire circle so that it is centered below the triangles of wire and the wire tail is parallel to the beginning wire segment as shown below-right. 

Step 28	Step 29	Step 30

These instructions continue on the next web page.