Making Jewelry by Stringing Beads on Bead Stringing Wire -- Page 15

Alternative Designs Continued:

Step 11:  Release the wire from your pliers and it should appear as shown at right. 

Step 12:  Pick up the wire and add your end cone to the 22 gauge wire with the wide end of the end cone first.  Push the end cone down as far on the wire as it will go.  Please note that we changed the orientation of the piece in the picture below-left. 

Step 13:  Holding the end cone down as far on the wire as it will go, grasp the wire immediately above the cone as shown below center-left. 

Step 14:  Bend the wire 90 degrees as shown below center-right. 

Step 15:  Grasp the wire with your round nose pliers as close to the 90 degree bend as possible, but on the horizontal wire segment.  In the next step we will make a loop in the wire at this point. 

Step 12	Step 13	Step 14	Step 15

These instructions continue on the following web page.