|
Step 1: Cut and straighten a 6 inch piece of 18 gauge or 20 gauge
wire. Step 2: Using your bent chain nose pliers,
make a right angle bend in this wire 2 inches
from one end. |
|
|
Step 3: Insert the 2" segment of bent wire into a WigJig Spiral
Maker and
begin making a spiral as described here.
Step 4: Continue making a spiral until all of your wire is used
in the spiral. When done, remove the wire from the Spiral Maker and
the spiral should appear as shown at right. |
|
| Step 5: Now insert two 8 mm beads onto the 2" segment of straight wire. The spiral shown in this picture is sitting flat, with the 2 inch segment of straight wire pointing up. The two crystal beads are threaded on the 2 inch segment of straight wire and slid down until they rest against the spiral. |
|
