 Step
9: Now push the wire with your thumb as close to peg 4 as
possible until the wire rests adjacent to peg 2 as shown at right.
It may be easier to remove peg 2 and push the wire slightly beyond the
hole for peg 2 then let it relax back to the position shown. When
you have the wire in position add peg 2 back to your pattern.Step
10: With peg 2 in position, remove peg 4 and push the wire until
with no pressure applied the wire remains in position immediately adjacent
to the empty hole for peg 4, then add peg 4 to your jig. At this
point your wire should appear as shown at right.
Step 11: Now push the wire with your thumb as close to peg
4 as possible until with no pressure applied the wire rests adjacent to
pegs 1 and 2. This may require first removing peg 2 then pushing the
wire slightly beyond peg 2 and replacing peg 2 after the wire
Step 12: Finally, we need to wrap the wire around peg 1 to finish the triangle shape. This is best done by pushing the wire with your thumb as close to peg 1 as possible. When completed, the wire should appear as shown at right. After this step is completed, remove the wire from the jig. If you have done each step correctly, the wire should remain in the shape shown. |
stays
next to the hole for peg 2. It may also require pushing the wire up,
over and beyond peg 1 so that with no pressure on the wire it will remain
in position immediately adjacent to peg 1.