Beads & Jewelry Wire Circles Earrings Jewelry Making Project          Page 3

Step 7:    Wrap the wire around peg 4 as shown at right.
 
 

Step 8:  Remove the wire from your jig.  You will need to lift each circle of wire gently in turn so that the wire component is not distorted by lifting it off your jig.  Once you have removed the wire from the jig, flip the wire over and reposition it back on your jig as shown at left. 

Step 9:  Now wrap the wire around peg 3 as shown at right.

Step 10:  At this point we need to remove the wire from the jig one last time.  Again, it is very important to gently lift the wire off the jig so that your wire component does not get distorted as you remove it from the jig.  Once it has been removed, flip the wire component over and replace it on the jig.  Once the wire is back on the jig, wrap the wire around peg 1 as shown at left.

Step 11:  Remove the wire from your jig.  The wire component should appear as shown here.  Cut the excess wire being certain to cut the wire with the flat side of your flush cutter toward the finished piece.  Using your bent chain nose pliers, close the final loop in your wire component.  This completes the Circles Wire Component.  Make two of these components. 

These instructions continue on the following page.