PG 13 Duplex Wire Bracelet with Beads Jewelry Making Project Page 13

Step 1b: Cut and make a loop in one end of a wire segment 4 1/8 inches long. Use 18 gauge for the first bracelet you make as it will be easier. Once you are familiar with the design, 16 gauge will make a slightly bolder look in your finished bracelet. Should you choose to use 16 gauge wire, you will need to use a WigJig Olympus or Olympus-Lite to make the duplex wire components. There is not adequate room on the WigJig Delphi for 16 gauge wire.

Step 2b: Straighten the wire by pulling it repeatedly through the jaws of nylon jaw pliers.

Step 3b: Follow steps 1 through 12 described beginning in page 2 for making the duplex wire component. Make five identical duplex wire components.

Deluxe Duplex Bracelet Jewelry Making Project Duplex Wire Component

Duplex wire Component

Step 4b: Cut and make a loop in one end of a wire segment 2 inches long.

Step 5b: Follow steps 15 through 18 as shown starting in page 4 to make the 2:1 or end wire component. Make two of these components.

Deluxe Duplex Bracelet Jewelry Making Project 2:1 Wire End Component
2:1 Wire Component

Page 13 Duplex Wire Bracelet with Beads Jewelry Making Project

Duplex Wire Bracelet with Beads Jewelry Making Project: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Duplex Wire Bracelet with Beads Jewelry Making Project: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17