| HOME BEGINNERS JEWELRY INSTRUCTIONS WIGJIG UNIVERSITY WHAT'S NEW GIFT IDEAS WIGJIG STORE |
| VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD TOOLS WATCHES WIRE |
Deluxe Duplex Bracelet
| Step 8b: Repeat steps 6b and 7b to connect all five duplex wire
components.
Step 9b: Now we need to connect the 2:1 end link to the duplex
wire components on either end. The process for connecting these two
end links is exactly the same as the process for connecting two duplex
wire components described in steps 6b and 7b. |
|
| Step 10b: At this point we are ready to add the clasp. A
medium size lobster claw clasp is a good choice for a clasp. You can
also use a magnetic clasp. With a lobster claw clasp, connect that
clasp to one of the end loops in the 2:1 end wire component using a medium
jump ring or a figure 8 connector and you are done. With a magnetic
clasp, you will need to use a figure 8 connector to connect each side of
the magnetic clasp to the end loop. As discussed earlier, if you
choose a magnetic clasp, you will also need a guard chain made of 2 1/2
inches of fine commercial chain. On the next page we will discuss the deluxe triplex bracelet. |
Page 15 Next Page
WigJig Jewelry
Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of
beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: February 24, 2008
