| For these earrings we will first show the pattern for making the
earrings on our new WigJig Centaur. On page 7
we will show the pattern for making these earrings on our other clear
WigJig jewelry making tools. Step 1: Cut and make a loop in one
end of a piece of wire 4 1/2 inches long. Use your Fine Step Jaw
pliers to make this loop. Use the first step for the Delphi or
Centaur and the second step for the Olympus, Electra or Olympus-Lite.
|
|
| Step 2: Using your nylon jaw pliers, straighten the wire. Step 3: Position your pegs in your jig as shown and place the initial loop on peg 1 with the wire resting inside peg 2. Step 4: Remove peg 3 so that it will not be in your way and wrap your wire around peg 2. Push the wire until it rests next to the hole for peg 3 as shown. You need to push the wire far enough that when you remove your hand, the wire will remain in the position shown. Step 5: Remove peg 4 and replace peg 3. Now bend the wire against peg 4 so that when you are done, the wire rests next to the hole for peg 5. |
 Step 3 |
 Step 4 |
 Step 5 |
Page 2 Next Page
WigJig Jewelry
Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of
beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: December 30, 2006
