| Step 8: At this point, insert your Fine Step Jaw Pliers into the
two loops of wire that were formerly around peg 1. Grasp the wire
tightly with your pliers and wrap the wire tail tightly around the wire
component about 2 times. When this step is completed, your wire
component should appear as shown at right. |
|
| Step 9: The wire component is completed by cutting the excess
wire with your flush cutter and squeezing the end of the cut wire flat
against the catch using either your bent chain nose pliers or your Bent
Closing Pliers. (You can find closing pliers in our Internet store
by searching on the term "closing".) |
|
| The catch finding that you just made is connected to your yoke by
wrapped bead links as shown at right.
Instructions for making this wrapped
bead link can be found here. Select the picture at right for a link to instructions on how to make this V Shaped Yoke. |
|
