|
Step 13: Make two spacer bars for each earring following steps 11 and 12. Step 14: Now we need to make a medium size jump ring to connect between the two spacer bar components and the ear wire finding. You could also connect the spacer bar components to the ear wire finding with a figure 8 connector. Either the jump ring or the figure 8 connector will work. (You can purchase a medium jump ring finding here.) Our instructions for making the jump ring can be found here. Our instructions for making a figure 8 connector can be found here. Make two jump rings or figure 8 connectors. For a beginner, we would recommend using figure 8 connectors instead of jump rings as the figure 8 connector is slightly easier to connect between the spacer bars and the ear wire finding.
Step 15: Once you have completed making two bottom wire
components, four spacer bar components and two jump rings or figure 8
connectors and you have your commercial ear wires, then you are ready to
Step 16: Open one end of the spacer bar and connect it to one side of the bottom wire component. Using a second spacer bar, perform the same steps on the opposite side of the bottom wire component. Step 17: Using a figure 8 connector, open one side of the Figure 8 connector and connect both spacer bars to that open figure 8 connector, then close the loop in the figure 8 connector. Open the top loop in the figure 8 connector and connect the jump ring finding. Using a medium jump ring, open the jump ring and connect both spacer bars and the ear wire finding to the open jump ring then close the jump ring. These instructions continue on the following web page. |
Step
12: Finish the spacer bar by cutting the excess wire with your
flush cutter, closing the loop in the wire with your bent chain nose
pliers and using your round nose pliers to convert the "P" loop to eye
loops. 
begin
assembling the earrings. The steps to assemble these earrings can
be found beginning below. 