Low Wall Bezel Jewelry Wire & Gemstones Earrings Jewelry Making Project -- Page 5

Step 18:  At this point we are ready to set the 10 gemstones into the low wall bezel findings.  Please select here to view our detailed instructions for setting gemstones in the low wall bezel findings.  Set all the gemstones into the low wall bezel findings. 

Step 19:  To connect the low wall bezel finding to the loops in the bottom wire component we use figure 8 connectors.  Make ten figure 8 connectors if you are using the 4mm findings or eight figure 8 connectors if you are using 6mm findings. 

Step 20:  For the 6mm findings, we use a small spacer bar finding to connect between the low wall bezel finding and the middle loop in the bottom wire component.  Use about 1 1/4" of wire and follow the pattern shown at left.  Follow our instructions here for making the spacer bar wire component. 

Step 21:  Use your figure 8 connectors to connect all 4mm low wall bezel findings to the five bottom loops in the bottom wire component.  Do this for both earrings.  Use the figure 8 connectors to connect four low wall bezel findings to the outside loops on the bottom wire component.  Use the small spacer bar component to connect one 6mm low wall bezel finding to the center loop in the bottom wire component.  Do this for both earrings. 

This should complete your earrings.  The 6mm style is shown above right and the 4mm style is shown at left.  We hope you like this project.  Because you are using gemstones and findings instead of wire components and beads, these earrings are slightly more expensive than many of our projects.  For us the results were worth it.