Milwaukee Jewelry Wire & Beads Earrings Jewelry Making Project -- Page 4

Step 11:  Wrap the wire around peg 4 as shown below-left.  Continue pushing the wire until the wire rests adjacent to the empty hole for peg 3 with no pressure applied. 

Step 12:  Remove the wire from the jig.  Add peg 3 back to the pattern and remove peg 6.  Replace the wire on the jig as shown below-center.

Step 13:  Wrap the wire around peg 5 as shown below-right.  Push the wire until it is adjacent to the empty hole for peg 6 with no pressure applied. 

Step 11	Step 12	Step 13

Step 14: Remove the wire from the jig.  Add peg 6 to the pattern and remove peg 1.  Replace the wire on the jig as shown below-left. 

Step 15:  Wrap the wire around peg 2 as shown below-center. 

Step 16:  Add peg 1 to the pattern and wrap the wire around peg 1 as shown below-right. 

These instructions continue on the following web page.