|
Step 23: Remove the wire from your jig and it should appear
as shown below-left.
Step 24: Cut the excess wire and close the final loop,
leaving your spacer bar
Step 25: Using your round nose pliers convert the "P" loops
on either end of your wire component to eye loops.
You can view
free instructions on how to do this here.
Step 26: Make two identical spacer bar components following the same instructions.
Step 28: The last component required to complete these earrings is ear wires. You can use a commercial ear wire that you purchase. You can also make your ear wires out of 3 inches of 20 gauge wire. Our free instructions for making ear wires can be found here. These instructions continue on the following web page. |
Step
27: Now we need to make a medium jump ring. You can
purchase jump rings if you don't want to make them. This is a
personal choice. We usually make our jump rings, because we aren't
good about planning ahead and having extra supplies lying around.
To make your jump ring you need fine step jaw pliers and a flush cutter.
