|
Step 8: In this step, we will add a new peg, remove the wire from the jig and replace it in the flipped position and then wrap the wire around the new peg. See the picture below-left and remember that we accomplished three things to get to the position shown. Step 9: At this point, we need to remove all the pegs from the jig. When we flip the pattern over during this step, we will need to reposition all the pegs. Position your pegs in the jig as shown below-center and replace your wire on these pegs as shown. Add a new peg to the pattern for the next loop. Unfortunately, it is a little complex to have to reposition your pegs to accommodate flipping the design over, but the end result is a wire component that will be just two layers of wire instead of a wire component that starts low and builds in height with each additional loop. Step 10: Wrap your wire around the new peg in the pattern as shown below-right.
These jewelry making instructions continue on the next page. |
