|
The peg pattern for making these earrings on one of our jigs with a square
pattern is shown at right. We will provide the peg patter for a
round jig toward the end of these instructions. Step 1: Cut a 4 1/2 inch long segment of 20 gauge wire. Half-hard wire is best if it is available, but soft wire will work. Make a loop in the end of this wire segment with the flush cut (not the sharp end). Step 2: Straighten this wire by pulling it repeatedly through the
jaws of nylon jaw pliers if you have them. |
|
| Step 3: Add pegs 1 and 2 to your jig and place the loop you just made on peg 1 as shown at right. |
|
