| Step 10: Now wrap the wire around peg 1. |
|
| Step 11: Remove the wire from the jig and cut the excess wire (with the flat side of the flush cutter toward the finished piece). Close the loop just completed. The wire component should appear as shown at right. |
 Step 11 |
| Step 12: Now grasp in turn the initial and then the final loops made around peg 1 with the tips of your round nose pliers. Convert each of these "P" loop into "eye" loops as shown here. |
 Step 12 |
| Step 13: Using your bent chain nose pliers, grasp in turn the initial loop and the final loop and twist them 90 degrees. These loops do not show in the picture at right because the camera is viewing the edge of these loops. |
 Step 13 |
