|
Step 14: We complete this wire component by grasping the initial and
final loops and bending them back to the position shown at right.
This will take some "hand finishing" meaning that you will need to bend
the wire by hand some until the wire rests in the shape shown at right.
|
|
|
Step 15: Cut a 1 inch segment of 20 g wire and make a Figure 8 connector
using the instructions provided here.
Step 16: Using the Figure 8 connector connect the wire component completed in Step 14 on one end to the ear wire finding on the other. Open and close the loops in the Figure 8 connector as described here. |
 |
