Suzanne's Jewelry Wire & Beads Earrings -- A Jewelry Making Project -- Page 3

Step 6:  Wrap the wire around the first peg as shown below-left.  Use your WigJig Spacer Press to push the wire down after you have completed wrapping. 

Step 7:  Remove the wire from the jig and reposition it onto the jig in the orientation shown below-right.  Essentially we are just flipping the wire over horizontally.  By doing this step, the finished wire component will be two layers of wire and will be more esthetically pleasing. 

Step 6	Step 7

Step 8:  Wrap the wire around the next peg as shown below-left.

Step 9:  Remove the wire from the jig and replace it in the position shown below-right. 

Step 8	Step 9

These instructions continue on the following web page.