Suzanne's Jewelry Wire & Beads Earrings -- A Jewelry Making Project -- Page 5

Step 14:  Wrap the wire around the peg as shown below-left.  Use your Spacer Press to push the wire down. 

Step 15:  Remove the wire from the jig and replace it in the position shown below-right.  This is essentially flipping the wire component over horizontally. 

Step 14	Step 15

Step 16:  Wrap the wire around the peg as shown below-left.  Use your Spacer Press to push the wire down.  (You can remove the next peg in the pattern if this makes it easier.)

Step 17:  Remove the wire from the jig and replace it in the position shown below-right. 

Step 16	Step 17

These instructions continue on the following web page.