|
Step 18: Wrap the wire around the peg as shown below-left. Step 19: Remove the wire from the jig. In this step you will need to do two things. First, you will need to reposition the wire tail of unused wire behind the initial wire segment. In the position shown for Step 18 the wire is on top of the wire segment between the second and third loops. You will need to gently reorient the wire tail so that it is behind the wire segment between the second and third loops. Once you have accomplished that, then you need to flip the wire segment over and reposition it on the jig as shown below-right.
Step 20: Wrap the wire around the next peg until it rests adjacent to the right side of the first peg. See the picture shown below-left. Please note that the picture below-left has a small error. You want to push the wire so that it is on the opposite side of the next peg (the empty peg in the pattern). It may be easier to remove the next peg in the pattern and push the wire until it rests adjacent to the opposite side of next peg with no pressure applied. Use your Spacer Press to push the wire down after you have completed the wrap. Step 21: Remove the wire from the jig and reposition in as shown below-right. In this picture we show the proper orientation of the wire adjacent to the next (last) peg in the pattern.
These instructions continue on the following web page. |
