Making a Square Chandelier Earring with Chain --
An Advanced Beginner's Jewelry Making Technique -- Page 3

Step 7:  Now we need to flip the wire component over so that the initial loop is on peg 5 and the second loop is on peg 4.  Add peg 3 to the pattern and remove pegs 1 and 2.  The reason that we do this is that the finished wire component will be two layers of wire instead of growing in layers with each additional loop that you make.  

Step 8:  Push the wire around peg 3 in the pattern.  Push the wire until it is adjacent to the empty holes for pegs one and two as shown below-left. 

Step 9:  Remove the wire from the jig.  Add pegs 1 and 2 and remove peg 5.  Position the initial loop on peg 1 as shown below-center. 

Step 10:  Push the wire around peg 4 as shown below-right.  Push the wire until it is adjacent to the empty hole for peg 5 with no pressure applied. 

Step 8	Step 9	Step 10

Step 11:  Add peg 5 to the pattern and push the wire around peg 5 as shown at right. 

These instructions continue on the next page.