 Now
we are ready to graduate to the Square Earring Stand. Unfortunately
unlike our earlier project, this stand doesn't end with lunch so it is a
good idea to begin this project after lunch.
We don't have a convenient template for this stand so we will make it by using a ruler to help us be consistent. Step 1: Cut a 24 inch segment of 12 gauge wire. Step 2: Using your round nose pliers, make a loop in one end of this wire. Step 3: Measure 2.5 inches and grasp your wire at this point with your bent chain nose pliers (BCNP). Bend the wire 90 degrees. Step 4: Measure 2.5 inches from that bend and grasp the wire at this point with your BCNP. Bend the wire 90 degrees up. Step 5: Measure 4 inches up and bend the wire 90 degrees pointing in a direction parallel to the initial loop. Step 6: Measure 3.5 inches across and bend the wire 90 degrees down. Step 7: Measure 4 inches and bend the wire 90 degrees away from the initial loop but in the same plane. Step 8: Measure 2.5 inches and bend the wire 90 degrees toward the bend you made in step 5. |