Page 9 of 15      Wire Jewelry Stands Jewelry Making Project

HOME   BEGINNERS JEWELRY INSTRUCTIONS   WIGJIG UNIVERSITY   WHAT'S NEW   GIFT IDEAS   WIGJIG STORE
VIEW OUR BEADS  BLING  BOOKS  CHAIN  FINDINGS  MISC  SUPPLIES  THREAD  TOOLS  WATCHES  WIRE

Jewelry Stands Jewelry Making Project:  1  2  3  4  5  6  7  8  9  10  11  12  13  14  15   
Jewelry Making Techniques         Dictionary of Jewelry Making Terms

Traveling Earring Stand Jewelry Making Project Step 9Step 9:  Wrap the wire all the way around peg 1. 

Bottom Wire Component of the Traveling Earring Stand Jewelry Making Project.Step 10:  Remove the wire from the jig and cut the excess wire from the final loop.  Close this loop using your bent chain nose pliers.  At this point the Bottom wire component will appear as shown at right.

Step 11 for Traveling  Earring Stand Jewelry Making ProjectStep 11:  To finish the bottom wire component we need to manipulate the wire with your bent chain nose pliers.  First, we need to re-orientate the two loops that were made on peg 2.  At this point the two loops are in the horizontal plane and we need to twist them so that they are in the vertical plane.  One at a time, holding the wire component with the fingers of your non-dominant hand, grasp the loop with the jaws of your bent chain nose pliers and twist it 90 degrees.  This will leave the beginning and ending loops up in the air while the remainder of the Bottom Wire Component is lying flat.

Page 9                    Next Page

Jewelry Stands Jewelry Making Project:  1  2  3  4  5  6  7  8  9  10  11  12  13  14  15   
Jewelry Making Techniques         Dictionary of Jewelry Making Terms

WigJig Jewelry Making Tools, Beads, Wire and Supplies Home
See our selection of beads, wire and jewelry tools.

IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted by WigJig.  Questions/Comments? 
WigJig is a registered trademark - Last modified: 9/25/2005