|
Step 8: Place the initial loop from the 5 inch wire segment on peg 3 with
the wire tail on the left side of peg 3. Now, as
shown at right, wrap the wire to the right and over peg 4, then under
and around and finally over peg 5. Now bring the wire under peg 4
and then over, around and under peg 6. From below peg 6, the wire is
wrapped over peg 4, down the left side of peg 4 and finally around the
right side of peg 3. Finish by making a loop around peg 3.
Step 9: Remove the wire from your jig and place the loops made around peg 3 on the stepped jaw of your step jaw pliers. While holding the wire component in your step jaw pliers and your pliers in your non-dominant hand, wrap the wire tail around the wire segment between pegs 3 and 4 as shown at right. Step 10. Cut the excess wire and using your bent chain nose
pliers gently squeeze the cut end so that it lies flat. See the
picture at right. |
|
