| Here is an alternative configuration for this V Shaped
Yoke that has bead strung on the short wire segment. The steps in
making this yoke are similar to the prior steps until Step 11.
First, the short wire segment must be made out of 20 gauge wire so that
you can string beads onto it. Second, with the initial loop in
place, thread about 5 4mm beads onto the short wire segment. |
|
| With the beads on the short wire segment, place the
initial loop on peg 6 and make a loop around peg 7 as shown at right.
Continue making your yoke as before. The finished yoke will appear
as shown, above-right. |
|
