|
Step 23: Now wrap the wire around peg 4 as shown at left.
Continue pushing the wire until the wire tail rests adjacent to the empty
hole for peg 6 with no pressure applied.
Step 24: For our last loop, we don't need to remove the wire from your jig. Just add peg 6 and wrap the wire around peg 6 as shown at right.
Step 27: At this time, we need to set our gemstones in our low wall bezel findings. Get your 10mm and 8mm low wall bezel findings (10mm is Item 3209 in gold-filled and item 3211 in sterling silver. 8mm is item 3210 in gold filled and item 3212 in sterling silver. You can view our selection of gemstones here.) Set both the 10mm and 8 mm gemstones following steps A through D shown below.
|
Step
22: Remove the wire from your jig. Add peg 7 to the
pattern and replace the wire on your jig with the initial loop on peg 7
with the remainder of the wire orientated
as shown at right. 
Step
25: Remove the wire from your jig and using your flush cutter,
cut the excess wire. Using your bent chain nose pliers, close the
final loop in your wire component. At this point, the bottom wire
component should appear as shown at left. 
Step
26: Now we are ready to connect the top and bottom wire
components. To do this, we first use our bent chain nose pliers and
open the loop on one end of the bottom wire component, connect that loop
to one of the bottom loops in the top wire component and again using our
bent chain nose pliers, close that loop. To connect the opposite
side of the top and bottom wire components is slightly more difficult.
You will need to open the end loop on that end of the bottom wire
component and open the end loop on the top wire component.
With both loops open, connect that side of the two components and then
close both loops. The two connected components should appear as
shown at right. 
