Beginners Jewelry Making using Beads, Tools, Wire & Supplies Page 20

Another jewelry making issue to discuss is durability. Jewelry wire is relatively soft by comparison with glass or stone. The inside of glass or stone beads has little microscopic irregularities that act as a saw and will cut thread or jewelry wire. Over time and with heavy wear, glass or stone beads can saw through wire. This effect can be minimized by using a bead reamer to remove some of the microscopic ridges inside the bead, but it can not be eliminated. Bracelets seem to be most vulnerable to this sawing action, but necklaces are also vulnerable. Anything that gets a lot of wear and as a result a lot of motion by the beads is vulnerable. The sawing action of the beads is a consideration whenever you are making a wrapped bead link connecting two wire components via a wire segment with the wire inside a bead. In general, it is easier to make a wrapped bead link with thinner wire, but thinner wire is less durable. 22G jewelry wire is recommended for making the wrapped bead link, but for a piece that will get a lot of wear, 20G wire may be a better choice.

The last jewelry making topic to discuss is hardening jewelry wire. Just as during the manufacturing process wire can be made in one of several hardness's, when making jewelry a wire artist can change the hardness of a jewelry wire component. Most of us have experience in breaking a wire coat hanger by bending it back and forth many times. With the coat hanger, we were changing the hardness of the wire by "work hardening" it. Each bend increased the hardness of the wire until we saw one of the drawbacks of very hard wire -- it became brittle and broke. With our jewelry wire components we want to make them permanent, so we frequently want to increase the hardness of the wire. This happens naturally as part of manipulating the wire into shape by work hardening. We can use nylon jaw pliers to help with this manipulation and by squeezing the piece in the jaws of the pliers we can work harden the piece. We can also significantly increase the hardness of the wire by hammering it with a chasing hammer and anvil. When making ear wires, this will be an important step to set the round portion of the ear wire and make it permanent. (Do not hammer where one wire segment crosses over another piece of wire.)

This WigJig jewelry making project is provided as part of WigJig University - College of Jewelry Making Designs. We try to provide interesting jewelry projects using beads, jewelry wire and other jewelry supplies. We hope that these pictures will provide you enough information for you to learn these jewelry making skills. We have tried in these pages to discuss the skills necessary for making jewelry in the detail that beginners need. We also suggest that beginners to jewelry making might need to visit the WigJig University College of Jewelry Making Techniques for additional information about some of the skills and techniques shown.

Most, but not all of the jewelry supplies shown here can be purchased in our WigJig store. We try to have a complete selection of jewelry supplies in our store including chain, wire, glass beads, findings, watches, tools, etc.

Page 20 Beads & Jewelry Making Supplies by WigJig -- Jewelry Making for Beginner's

Jewelry Making -- Choosing Your Jewelry Wire (Continued)