| Step 7: Remove the wire from the jig and cut the excess wire. Close the final loop. |
|
| HOME BEGINNERS JEWELRY INSTRUCTIONS WIGJIG UNIVERSITY WHAT'S NEW GIFT IDEAS WIGJIG STORE |
| VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD TOOLS WATCHES WIRE |
| Step 7: Remove the wire from the jig and cut the excess wire. Close the final loop. |
|
| Step 8: Now using your second three inch segment of 20 gauge
wire place the loop in the wire over the left most peg as shown below,
left. Wrap your wire around the top peg and down to the right most
peg. Push your wire far enough, so that with your hands removed, the
wire will stay in the position shown below left.
Step 9: Wrap your wire around the bottom right peg as shown below, center.
Step 10: Remove the wire from the jig and cut the excess wire.
Close the final loop. When completed the wire should appear as
shown below, right. |
|
|
|
|
Page 3 Next Page
WigJig Jewelry
Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of
beads, wire and jewelry supplies.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 09/04/2008
