|
Step 1: Cut and straighten a piece of 1/2 hard wire 2 inches long. Step 2: Make a 1/2 loop in the end of this piece of wire. |
|
|
Step 3: Position the pegs in your jig as shown on the previous page. Step 4: Place your wire on the jig as shown at right. |
|
|
Step 5: Wrap your wire around the top peg in the pattern as shown at
right. Step 6: Remove the wire from the jig and remove the bottom, right peg. Replace the bottom right peg in the position as shown below. Replace the wire back on these pegs as shown in the picture below. Step 7: Wrap the wire around the bottom left peg as shown below right. |
|
|
|
|
Page 6 Next Page
WigJig Beads, Wire, Jewelry Making Tools and Jewelry Supplies Home
See our selection of
beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: February 24, 2008
This WigJig jewelry project is provided as part of WigJig University - College of Jewelry Designs. We try to provide interesting jewelry projects using beads, jewelry wire and other jewelry supplies. We hope that these pictures will provide you enough information for you to complete this project. Some of the skills and techniques shown have not been discussed here. For beginners, we suggest that you visit our Beginners Start Here pages. These pages discuss the skills necessary for making jewelry in the detail that beginners need. We also suggest that beginners to making jewelry might also need to visit the WigJig University College of Jewelry Techniques for additional information about some of the skills and techniques shown.
Most, but not all of the jewelry supplies shown here can be purchased in our WigJig store. We try to have a complete selection of jewelry supplies in our store including chain, wire, glass beads, findings, watches, tools, etc.