|
Step 1: This jewelry making project starts by making two Flemish
Spiral wire components which will ultimately become the clasp for the
necklace. The peg pattern for making this component is shown below,
right. It requires two regular metal pegs and two 3/16" Super Pegs.
Position your pegs in your jig as shown. (The WigJig Delphi is
shown, but this pattern can also be made in the Olympus or Olympus-Lite.) |
|
|
Step 2: Cut two three inch long segments of 18 gauge wire. 1/2
hard wire works best if available. Step 3: Make a loop in one end of the wire using your round nose pliers (or step jaw pliers if you have them). |
|
