| The WigJig jewelry component that we
use for
this bracelet is called a Flemish Spiral. I don't know why is it
called this, as it doesn't look like a spiral; but my mother called it by
that name and I can't argue with her. The peg patterns for square
pattern jigs is shown at right. The peg pattern for round pattern jigs
is shown at bottom right. Here are the instructions for making the Flemish
Spiral. |
Delphi/Olympus Peg Pattern
|
After Wrapping Wire on Delphi
|
After Wrapping Wire on Olympus or Olympus-Lite
|
| This jewelry wire component is made by making a loop in
a piece of 18G wire (preferably 1/2 hard wire) about 4 inches long using
your round nose pliers. After straightening this piece of wire, place
the initial loop over the first regular peg (smaller pegs shown in these
pictures) on your jig. Wrap the wire around the pegs in turn.
Remove from the jig and cut the wire tail off. Close the final loop
you just made and the piece should appear as shown below. |
After Wrapping Wire in Cyclops or Electra
|
