| Step 5: Continue wrapping the wire around the bottom two pegs until you have four full loops of wire. |
|
| Step 6: Wrap the wire tail around the middle peg as shown at right. |
|
| Step 7: Remove the wire from the jig and flip it over. Wrap the beginning of the wire around the middle peg as shown at right. |
|
| Step 8: Now we need to position the wire so that we can twist it. We have a loop in the wire on either end. Position your Fine Step Jaw pliers into one of these loops. Using a long metal peg (an accessory for our WigJig tools), slide this long peg into the other loop in the wire. See the picture at right for how this should appear. |
|
