| HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE |
| VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE |
|
Step 13: Make at least three of these Scepter Links using the steps
that were described previously. |
|
|
Step 14: The bracelet shown at right was made with 8mm Black Lace
Agate beads (the white "lace" in the beads does not show well in these
photographs.) The bracelet is made by first connecting two of the
Scepter Links together using a wrapped
bead link. Then connect the third Scepter Link to one end of the
other two with the same wrapped bead link. |
|
| Step 15: With all three links connected together, add two wrapped bead links to either end of the three Scepter links. |
|
| Step 16: In order to make this bracelet come out to be 7 1/2 inches long, two 4mm beads were used to connect either end of the bracelet to the clasp. Again, the wrapped bead link was used with these 4 mm beads. In the bracelet shown, a 6mm gold-filled magnetic clasp was used. Whenever a magnetic clasp is use for a bracelet, it is a very good idea to use a guard chain about 2.5 inches long made of fine, commercial chain. This guard chain is attached at the same time as the clasp, before the link holding the clasp is wrapped closed. This completes this bracelet project. |
Page 5 Next Page
WigJig Jewelry
Making Tools, Beads, Supplies and Jewelry Wire
See our selection of
beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 09/04/2008