| Step 3: Place three pegs in your jig as shown at right and place
the loop in the wire over the lower peg in the pattern.
Step 4: Make a loop around the peg on the right, as shown below, left. Step 5: Remove the wire from the jig and replace it in a mirror image position, keeping the bottom loop on the bottom peg and moving the loop you just made to the opposite peg, upper left. See the picture below, center. Sept 6: Now make a loop around the peg on the right again. See the picture below, right. As with making this component, in the next steps, we will continue this process of making a loop on the peg on the right, removing the wire and flipping it over and again making a loop on the peg on the right. |
|
|
Step 4 |
Step 5 |
Step 6 |
Page 3 Next Page
WigJig Jewelry
Making Tools, Beads, Wire and Supplies Home
See our selection of
beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: February 24, 2008
This WigJig jewelry project is provided as part of WigJig University - College of Jewelry Designs. We try to provide interesting jewelry projects using beads, jewelry wire and other jewelry supplies. We hope that these pictures will provide you enough information for you to complete this project. Some of the skills and jewelry making techniques have not been discussed here. For beginners, we suggest that you visit our Beginners Start Here pages. These pages discuss the skills necessary for making jewelry in the detail that beginners need. We also suggest that beginners to making jewelry might need to visit the WigJig University College of Jewelry Techniques for additional information about some of the skills and techniques shown.
Most, but not all of the jewelry supplies shown here can be purchased in our WigJig store. We try to have a complete selection of jewelry supplies in our store including chain, wire, glass beads, findings, watches, tools, etc.