| HOME JEWELRY MAKING INSTRUCTIONS WIGJIG UNIVERSITY NEWSLETTER GIFT IDEAS WIGJIG STORE |
| VIEW OUR BEADS BLING BOOKS CHAIN FINDINGS MISC SUPPLIES THREAD JEWELRY TOOLS WATCHES WIRE |
How To Knit Wire with a Spool Knitter Pages:
1 2
3 4
View our Free Jewelry Making Instructions
Jewelry Making Skills
Jewelry Making Supplies
Jewelry
Making Tools
|
Step 5: Now using the stylus that comes with the
Spool Knitter, pull the first loop of wire around peg 1 up and over peg 1,
leaving the second wire loop on the outside of peg 1. See the
picture at right.
|
|
|
Step 6: Pull the bottom wire to remove the slack
in the loop you just created.
Step 7: Wrap the wire outside of peg 2 to the outside of peg three. Step 8: Using the stylus, pull the lower (first) loop on peg 2 out and over peg 2 leaving the second loop in place. Step 9: Pull the bottom wire to remove the slace in the loop you just created. |
|
|
Step 10: Continue the steps above as you knit the wire
chain. Try to pull with consistent pressure on the wire.
Step 11: When the chain has reached the length you require, remove the wire from the spool knitter and thread the loose wire end through all the loops in the wire. Pull this wire tight to ensure that your knitted wire will not unravel. |
![]() |
Page 3 Next Page
How To Knit Wire with a Spool Knitter Pages:
1 2
3 4
View our Free Jewelry Making Instructions
Jewelry Making Skills
Jewelry Making Supplies
Jewelry
Making Tools
WigJig Jewelry
Making Tools, Beads, Wire and Jewelry Supplies Home
See our selection of
beads, wire and jewelry tools.
IMPORTANT PRINTING INSTRUCTIONS
All content on this web site is copyrighted© by WigJig. Questions/Comments?
WigJig® is a registered trademark - Last modified: 09/04/2008